Air Skids

Instrument Air Compressor and Starting Air Compressor skids are usually designed and constructed to customer specifications.

Products are designed using 3D Autodesk INVENTOR 2012, and manufactured in house , adhering to standardized quality control procedures. Critical steps in the fabrication process such as cutting, welding, piping, wiring and painting are performed by fabricator-welders, mechanics and technicians experienced in their craft with a proven track record of success in producing quality equipment. The end result is a consistent level of high quality that ships on time and performs as expected.

Our 16,000 sq. ft. shop is located on over an acre with an overhead crane, welding shop, metal-cutting saws and paint booth. A 600-amp test stand allows full load testing up to 250 HP and a VFD drive allows testing with 50 Hz power, common for international voltages.

  • Onshore and Offshore environments
  • Hazardous locations
  • High or low ambient conditions

Instrument Air Skids

Typically instrument air packages are designed to meet ANSI/ISA-S7.3 quality standards for Dew Point (-40F), Oil Content (less than 0.01 ppm), Particulate,(less than 0.01 micron)and temperature (100F). Duplex compressors are standard, with options for wet and dry receivers, duplex or simplex dryers and a host of options for controls and instrumentation.

Starting Air Skids

Air Start Skids can be relatively small diesel powerd reciprocating compressors for land rigs or larger rotary screw units driven by diesel engines or electric motors for starting natural gas engines. Typically design pressures are 200 to 250 PSIG and include wet receivers